Can 1060 aluminium sheet be oxidized

This 1060 aluminum alloy has excellent forming capability by cold or hot working with commercial techniques.

Alloy:1060

Width:100-2600mm

Thickness:0.2-4.5mm

Physical Data of 1060 aluminum sheet :

Density (lb / cu. in.) 0.0975

Specific Gravity 2.705

Melting Point (Deg F) 1200

Modulus of Elasticity Tension 10

Modulus of Elasticity Torsion 3.85

1060 aluminium sheet belongs to pure aluminium sheet and can be oxidized, but 1060 aluminium sheet can be divided into cold-rolled sheet and hot-rolled sheet. The production of China aluminium sheet is mainly made of cold-rolled sheet with a large amount of usage and a wide range. However, after the cold rolled aluminum sheet is oxidized, there will be a lot of water ripple and color difference. Hot rolled aluminium sheet plate mainly with different raw materials, hot-rolled aluminum sheet plate can be oxidized, and the effect of oxidation is also very good. It is suggested that if the 7075 aluminum high toughness aluminium plate is oxidized with 1060 aluminium plate, it is better to use hot rolled aluminum sheet to oxidize.

Aluminum 1060 is stocked by 0 North American distributors and produced by 4 large mills. Distributors will offer small quantity buys while mills will generally only sell large quantities, with delivery times anywhere from 10 to 50 weeks depending on size and form required

1060 aluminum sheet is widely used in signs, billboards, building exterior decoration, bus body, tall buildings and factory wall body adornment, kitchen sink, lamp holder, fan blade, electronic parts, chemical equipment, mechanical parts, deep drawing of sheet or spinning concave ware, welding part, heat exchanger, clock surface and plate, plate, kitchenware, ornaments, reflective equipment, etc

Oxidized 1060 aluminum sheet Have good elongation and tensile strength, can satisfy completely the requirements of conventional processing (stamping, stretch) high formability. For industrial pure aluminium, high plasticity, corrosion resistance, electrical conductivity and thermal conductivity, but strength is low, heat treatment can not be improved machinability is bad; Gas welding, hydrogen welding and resistance welding, is not easy to brazing; Under various pressure processing and extension, bending.

Related Posts

Leave a Reply

Your email address will not be published. Required fields are marked *